Coolant Replacement - KYMCO People GT 200i Service Manual

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

12
. COOLING SYSTEM

COOLANT REPLACEMENT

The engine must be cool before serving
the cooling system, or severe scalding
may result.
Open the radiator protector and remove the
radiator cap.
Place a drain pan under the water pump
and drain the coolant from the system by
removing the drain bolt.
Fill the system with a 40-60 mixture of
distilled water and ethylene glycol.
Bleed air from the system
1.Start the engine and allow it to run until
there are no air bubbles in the coolant,
and the level stabilizes.
2.Open the air vent tube to see the hot
coolant flow out.
3.Stop the engine and add coolant up to the
proper level if necessary.
4.Reinstall the radiator cap.
5.Check the level of coolant in the reserve
tank and fill to the correct level if the level
is low.
6.Close the radiator protector.
People GT 200i
Drain Bolt
Air Vent Tube
12-5

Advertisement

Table of Contents
loading

Table of Contents