Rear Fork - KYMCO People GT 200i Service Manual

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

15. REAR BRAKE/REAR FORK/REAR
WHEEL/REAR SHOCK ABSORBER
INSTALLATION
Install the brake caliper to the rear fork and
tighten the two bolts.
Torque: 35 N-m
Connect the brake fluid tube to the brake
caliper and install fluid tube bolt, copper
washers and tighten the fluid tube bolt.
Fill the brake reservoir with the specified
brake fluid and bleed air from the brake
system. ( 14-10)
When installing the brake fluid tube, be
sure to install the two copper sealing
washers.

REAR FORK

REMOVAL
Remove the exhaust muffler. ( 2-10)
Remove the rear brake caliper. ( 16-3)
Remove the right rear shock absorber lower
mount bolt.
Remove the rear axle nut and remove the
collar.
Remove the rear fork.
The installation sequence is the reverse of
removal.
Turn the inner race of each bearing with your
finger to see if they turn smoothly and quietly.
Also check if the outer race fits tightly in the
hub.
Replace the bearings if the races do not turn
smoothly, quietly, or if they fit loosely in the
hub.
Fluid Tube Bolt
Brake Caliper
Bolts
Bolt
People GT 300i
15-4

Advertisement

Table of Contents
loading

Table of Contents