KYMCO People GT 200i Service Manual page 72

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

7. CYLINDER/PISTON
Inspect the piston, piston pin and piston
rings.
Remove the piston rings.
Take care not to damage or break the
piston rings during removal.
Clean carbon deposits from the piston
ring grooves.
Install the piston rings onto the piston and
measure
the
clearance.
Service Limits:
Top: 0.09 mm replace if over
2nd: 0.09 mm replace if over
Remove the piston rings and insert each
piston ring into the cylinder bottom.
Use the piston head to push each
piston ring into the cylinder.
Measure the piston ring end gap.
Service Limit: 0.5mm replace if over
Measure the hole I.D. of piston pin
Service Limit: 15.04 mm replace if over
piston
ring-to-groove
People GT 200i
7-4

Advertisement

Table of Contents
loading

Table of Contents