KYMCO People GT 200i Service Manual page 200

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

17. IGNITION SYSTEM
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• Some electrical components may be damaged if terminals or connectors are connected or
disconnected while the ignition switch is "ON" and current is present.
• When servicing the ignition system, always follow the steps in the troubleshooting on page 17-2.
• The ignition timing cannot be adjusted since the ignition control module is already adjusted in
factory.
• The ignition control module or ECU maybe damaged if dropped or the connector is disconnected
when the key is
ECU. Always turn off the ignition switch before servicing.
• A faulty ignition system is often related to poor connections. Check those connections before
proceeding.
• Make sure the battery is adequately charged. Using the starter motor with weak battery results in
a slower engine cranking speed as well as no spark at the spark plug.
• Use a spark plug of the correct heat range. Using spark plug with an incorrect heat range can
damage the engine.
SPECIFICATIONS
Spark plug
Spark plug gap
Inductive Ignition Coil
Throttle Position Sensor
Fuel Pump
Fuel Injector
Water Temperature Sensor
Oxygen Sensor ( engine warming condition )
Crank Position Sensor
Tilt Switch
TROUBLESHOOTING
No peak voltage
• Short circuit in engine stop switch or ignition switch wire.
• Faulty engine stop switch or ignition switch.
• Loose or poorly connected ignition control module connectors.
• Open circuit or poor connection in ground wire of the ignition control module.
• Faulty crank position sensor.
• Faulty ignition control module.
Peak voltage is normal, but no spark jumps at the plug
• Faulty spark plug or leaking ignition coil secondary current.
• Faulty ignition coil.
ON
, the excessive voltage may damage the ignition control module or
Item
Standard type
Primary coil
Secondary coil without plug
cap
People GT 200i
Standard
NGK CR7E
0.6 ~ 0.7 mm
3.57~4.83
10.42~14.49 K
3500~6500
1.9
about
11.7 0.6
2.076K
10% (25 )
6.7 ~9.5
115
15
0.4V~1.4V(normal)
3.7V~4.4V (fall down)
17-2

Advertisement

Table of Contents
loading

Table of Contents