Service Information - KYMCO People GT 200i Service Manual

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

13. FUEL INJECTION SYSTEM

SERVICE INFORMATION

GENERAL INSTRUCTIONS
● Scooter services can be done with the engine installed in the frame.
● Be sure to relieve the fuel pressure before fuel pump or fuel hose removal.
● Bending or twisting the control cables will affect operation and could cause the cables to stick or
bind, resulting in loss of vehicle control.
● Work in a fully ventilated area. Smoking or allowing flames or sparks in the work area or where
gasoline is stored can cause a fire or explosion.
● Do not snap the throttle valve from fully open to fully close after the throttle cable has been
removed; it may cause incorrect idle speed.
● Do not loosen or tighten the painted bolts and screws of the throttle body. Loosening or tighten
them can cause throttle and idle valve synchronization failure.
● Seal the cylinder head intake ports with tape or a clean towel to prevent dirt and debris from
entering the intake ports after the throttle body has been removed.
● Do not damage the throttle body. It may cause incorrect throttle and idle valve synchronization.
● Do not take the fuel pump on the ground downward.
● Always replace the packing when the fuel pump is removed.
● The electronic fuel injection system is equipped with the self-diagnostic system. If the Check
Engine Lamp "CELP" illuminate while riding, follow the self-diagnostic procedures to solve the
problem.
● A faulty AFI problem is often related to poorly connected or corroded connectors. Check those
connections before proceeding.
● When disassembling the fuel injection parts, note the location of the O-rings. Replace them with
new ones upon reassembly.
● Do not disconnect the battery negative (-) or positive (+) cable while engine is running, it may
cause ECU damage.
● Do not disconnect or connect the ECU connector during the ignition switch "ON"; it may
cause the ECU damage.
13-1
People GT 200i

Advertisement

Table of Contents
loading

Table of Contents