KYMCO People GT 200i Service Manual page 126

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

12
. COOLING SYSTEM
THERMOSTAT
THERMOSTAT REMOVAL
REMOVAL
Remove the met-in box and carrier.
Remove the body cover, center cover and
rear
fender cover A.
Drain the coolant.
Disconnect the thermosensor wire from the
thermosensor.
Disconnect the water hose from the
thermostat housing.
Disconnect the air vent tube from the
thermostat housing.
Remove the mounting bolt and the
thermostat housing from the cylinder head.
Remove two bolts and separate the
thermostat housing halves.
Remove
the
thermostat housing.
INSPECTION
Suspend the thermostat in a pan of water
over a burner and gradually raise the water
temperature to check its operation.
Begins to open
Full-open
Valve lift
• Do not make the thermostat touch the
pan as it will give a false reading.
• Replace the thermostat if the valve
stays open at room temperature.
• Test the thermostat after it is opened
for about 5 minutes and holds the
temperature at 70 .
INSTALLATION
Replace the O-ring with a new one and
apply grease to it.
Fill the cooling system with the specified
coolant.
thermostat
from
71
80
3.5 4.5mm
the
Thermostat

People GT 200i
Bolts
Thermosensor Wire
Thermostat
Thermometer

12-13

Advertisement

Table of Contents
loading

Table of Contents