KYMCO People GT 200i Service Manual page 73

Hide thumbs Also See for People GT 200i:
Table of Contents

Advertisement

7. CYLINDER/PISTON
Measure the piston pin O.D.
Service Limit: 16.994 mm replace if
below
Measure the piston O.D.
Take measurement at 9mm from the
bottom and 90° to the piston pin hole.
Service Limit: 65.90mm replace if below
Measure
the
clearance.
Service Limit: 0.02mm replace if over
CYLINDER INSPECTION
Inspect the cylinder bore for wear or
damage.
Measure the cylinder I.D. at three levels
of top, middle and bottom at 90° to the
piston pin (in both X and Y directions).
Service Limit:
66.10 mm repair or replace if over
Measure the cylinder-to-piston clearance.
Service Limit:
0.1 mm repair or replace if over
The true roundness is the difference
between the values measured in X and Y
directions. The cylindricity (difference
between the values measured at the
three levels) is subject to the maximum
value calculated.
Service Limits:
True Roundness:
0.05mm repair or replace if over
Cylindricity: 0.05 mm repair or replace if
over
7-5
piston-to-piston
pin
Top
Middle
Bottom
People GT 200i

Advertisement

Table of Contents
loading

Table of Contents