KYMCO People GT 200i Service Manual page 7

1. GENERAL INFORMATION
After operation, terminal caps shall be
installed securely.
When taking out the connector, the lock on
the connector shall be released before
operation.
Hold the connector body when connecting
or disconnecting it.
Do not pull the connector wire.
Check if any connector terminal is bending,
protruding or loose.
The connector
completely.
If the double connector has a lock, lock
it at the correct position.
Check if there is any loose wire.
Confirm
Capacity
shall be inserted
Before connecting a terminal, check for
damaged terminal cover or loose negative
terminal.
Check the double connector cover for
proper coverage and installation.
Insert the terminal completely.
Check the terminal cover for proper
coverage.
Do not make the terminal cover opening
face up.
Secure wire harnesses to the frame with
their respective wire
designated locations.
Tighten the bands so that only the
insulated surfaces
harnesses.
After clamping, check each wire to make
sure it is secure.
People GT 200i
bands at the
contact the wire
1-4