General Settings - Microscan MS-3000 User Manual

Chapter 4 Profile Card Configuration

General Settings

Mode 0: Write, Read, Default, Menu
Data Switches
1 2 3 4
Write
Read
Default
Menu
Note: Unintentional defaults may occur when using the profile card's write
functions (modes 0 and 1) to copy configuration changes from versions -26
and earlier to versions -27 and later (and vice versa), and when copying
from versions -27 through -31 to versions -32 and later (and vice versa)
of Microscan standard firmware.
to the same firmware version, use a separate profile card for each version
group, or use a single profile card to first make all configuration copy
changes within one group (those with all earlier or all later versions) and
then, after individually changing the settings in one decoder of the second
group, copying them to the other decoders in that group.
1. The firmware number is 35-213001-XX for the MS-3000 single head decoder. The XX
is substituted here for the version number. The firmware version can be found on a
label on the EPROM, displayed in the heading of the Main menu in the Configuration
program, or on later versions, displayed by invoking the <#> serial operational com-
mand. You can also call-in the serial numbers of the decoders to Microscan to get the
firmware versions issued with those decoders.
4-4
MS-3000 Single Head Decoder User's Manual
Mode Switches = On
= Off
1
To solve, you can change all EPROMs