Trigger Filter Timing Value - Microscan MS-3000 User Manual

access. If this should occur, try gaining access to the decoder by use of a pro-
1
file card or by entering a <D> command from an auxiliary terminal via the
auxiliary RS-232 port. If neither of these methods is available, try defaulting
the decoder. See Appendix C, "Defaulting the Decoder," on page

Trigger Filter Timing Value

Format: <KF?>
Returns the current trigger filter timing value in milliseconds.
Format: <KFone tenth trigger filter timing value>
Allows you to set trigger filter timing. Divide the desired number of millisec-
onds by 10 and enter the quotient.
1. See mode 0 in Chapter 4, "Profile Card Configuration."
MS-3000 Single Head Decoder User's Manual
A-4.
3-5