Microscan MS-3000 User Manual page 69

RS-422
Format: <KbRS-422 status>
RS-422 status:
0 = Disabled 1 = Enabled
Example: To enable RS-422, enter <Kb1>.
This command assumes the decoder is in RS-232 before RS-422 is
enabled. If a multidrop address has been already assigned, the decoder will
be in RS-485 communications, regardless of RS-422 status.
Host Port Status Request
Format: <KU?>
Returns status of Host Port <Ka> and RS-422 <Kb>.
Auxiliary Port
Format: <Kystatus,baud rate,parity,stop bits,data bits>
status: baud rate:
0 = Disabled 0 = 600
1 = Transparent 1 = 1200
2 = Half Duplex 2 = 2400
3 = Full Duplex
parity: stop bits:
0 = None 0 = One
1 = Even 2 = Odd 1 = Two
Example: To enable Half Duplex and to change the baud rate to 2400, enter
<Ky2,2>.
Communications Status Request
Format: <KT?>
Returns status of each command in the group.
MS-3000 Single Head Decoder User's Manual
Communications Commands
3 = 4800
4 = 9600
5 = 19.2K 6 = 38.4K
data bits:
0 = Seven
1 = Eight
3-9