Microscan MS-3000 User Manual page 29

For example, to enable LRC (see
Structure," on page 2-5 and "Longitudinal Redundancy Check" on
page 2-10), you would use the following command line path:
Main —> Communications
Main —> Operations
Main —> Code Types
Main —> User Outputs
Main —> Raster Setup
Communications —> Host Protocol
Communications —> Host Port
Communications —> Aux Port
Host Protocol —> Protocol
Host Protocol —> Preamble = ^M
Host Protocol —> Preamble = Disabled
Host Protocol —> Postamble = ^M^J
Host Protocol —> Postamble = Disabled
Host Protocol —> LRC = Disabled
Host Protocol —> Response Timeout
Host Protocol —> Intercharacter Delay
Host Protocol —> LRC = Disabled
Host Protocol —> LRC = Enabled
To view LRC's new status in the menu, press M to refresh the screen. To
return to the Main menu, press M again. You can make additional changes
within another menu before exiting the program. Simply follow the same
method of scrolling to and selecting each main topic, then its subtopics, until
you reach the parameter you want to change. Remember, to return to the
Main menu at any time, press ESC (escape key) and M.
Some parameters are user defined, in which case they prompt you with an
arrow for data, such as:
At the prompt, redefine the parameter within the allowable range, and press
CR to enable.
MS-3000 Single Head Decoder User's Manual
figure 2-2, "Communications Menu
From the Main menu, press
CR at the Communications
prompt (this is the first prompt
displayed in the Menu Config-
uration Program) to access the
Communications menu.
Since LRC is a subtopic of
Host Protocol, press CR to
access the Host Protocol
parameters.
Protocol is the first parameter
under Host Protocol. Press SP
until you reach LRC, then
press CR.
in 1ms incs = 12
in 1ms incs = 0
To enable LRC, press CR, SP,
and CR.
2-3