Microscan MS-3000 User Manual page 27

Chapter
2
Communications Menu ........................................................................ 2-5
Operations Menu ............................................................................... 2-13
Code Types Menu.............................................................................. 2-22
User Outputs Menu............................................................................ 2-29
Raster Setup Menu ............................................................................ 2-33
This chapter describes how to configure the MS-3000 decoder with on
screen menu commands from a host or auxiliary terminal.
All keystrokes are in bold typeface.
Default parameters in the menu structures are also in bold typeface.
All of these parameters, with the exception of Full Screens, can also be
changed by serial commands (see
In addition, most of these configuration parameters can also be changed
with a Microscan profile card (P/N 99-500011-01), obtainable from your
Microscan representative (see
Communicating with an ASCII Terminal
The MS-3000 decoder communicates in full duplex, terminal mode with no
handshake. It also recognizes carriage returns and line feeds.
The host or ASCII terminal with must match the following default settings
before any communication can take place: 9600 Baud Rate, Seven Data
Bits, Even Parity, and One Stop Bit.
MS-3000 Single Head Decoder User's Manual
Menu
Configuration
Chapter Contents
Chapter 3, "Serial Configuration").
Chapter 4, "Profile Card Configuration").
2-1