Chapter 1 Setup And Installation; Step 1 - Plan Scanning System; Figure 1-1 System Diagram - Microscan MS-3000 User Manual

Chapter 1 Setup and Installation
1
Plan Scanning System
Before installing the MS-3000 decoder you should sketch out a diagram of
your scanning system, showing equipment, connector and cable types, and
cable lengths.
Figure 1-1 shows a possible scanning system setup. There are six I/O con-
nectors on the MS-3000 decoder: the 25-pin host connector (see
on page 1-9), a 6--pin trigger connector (see
5-pin power connector (see
scan head connector (see
connector (see figure 1-8 on page
(see figure 1-11 on page
Bar-coded
item flow
1-2
MS-3000 Single Head Decoder User's Manual
figure 1-4 on page
figure 1-7 on page 1-6), the modular RJ-45
figure 1-5 on page 1-5), the modular RJ-11 LAN
1-7), and the 9-pin monitor connector
1-9).
Optional
monitor
Object
MS-3000
Detector
Deco der
8-pin cable
Power
pack
Scan Head

Figure 1-1 System Diagram

figure 1-9
1-5), the
Host
To optional multidrop
concentrator
To 120/240 VAC
pow er supply