Attach The Motorized Barrier Filter Wheel (Optional) - Nikon Eclipse Ni-E Instruction Manual

11

Attach the motorized barrier filter wheel (optional).

Tool: Hex driver (2 mm across flats)
Hex driver (2.5 mm across flats, included with barrier filter wheel)
Attach the motorized barrier filter wheel on the
epi-fluorescence cube turret and epi-fluorescence
attachment.
(1) Remove the contact cover on the top of the
epi-fluorescence cube turret.
(2) Loosen the fixing screw on the front of the
epi-fluorescence cube turret using a hex driver
(2 mm across flats) so that the tip of the fixing screw
does not protrude into the connecting section.
(3) Loosen the set screws (x2) on both sides of the
motorized barrier filter wheel with a hex driver
(2.5 mm across flats).
(4) Engage the round dovetail and the convex contact at
the bottom of the motorized barrier filter wheel with
the dovetail and concave contact of the
epi-fluorescence cube turret, and then slide the
entire mounted units to the rear side.
(5) Tighten the fixing screw loosened in (2).
(6) Tighten the screws (x2) on the top of the motorized
barrier filter wheel using a hex driver (2.5 mm across
flats).
(7) Tighten the set screws loosened in step (3).
The location of the fixing screws at the front of the
epi-fluorescence cube turret is deep so it will be easier
that you insert the hex driver (2 mm across flats) into the
screw before placing the epi-fluorescence cube turret or
that you have a pen light when working.
Chapter 1
Assembly
Fixing screw
Attaching the motorized barrier filter wheel
14
Contact cover
1
O
2 5
1
3
6
4
7
8
P
A. STO
P
F. STO
2
3
4
5
6
Barrier filter wheel
fixing screw
Set screw