Check Input Voltage; Unfasten The Elevating Section - Nikon Eclipse Ni-E Instruction Manual

Assemble the device in accordance with the following procedure.
Cables are required for some motorized devices, but assembly may be easier if cables are connected after all devices are
assembled. See "25 Connect the motorized unit cable" for the locations of all cables.
Precautions for connecting a cable
Cable connections are required for some motorized and peripheral devices.
Be sure to turn off the power to the microscope and peripheral devices before starting cable connection.
Cable connections are described in each assembly step. Nikon recommends connecting cables at the end of the
assembly (except when connecting a cable for the motorized universal condenser). See "25 Connect the motorized
unit cable." for the connector connections.
Information setting regarding motorized models
Set information of the motorized devices or optical element attached on the microscope setup menu for the DS-L3 DS Camera
Control Unit. (See Chapter 3 "23 Operation on DS-L3" - "23.1 Setting Up the Microscope.)
1

Check input voltage.

Check the input voltage indicated on the back of control
box A. Use the microscope only if the indicated input
voltage matches the power supply voltage for the area in
which the microscope will be used.
WARNING
If the indicated voltage and the supplied voltage differ,
do not attempt to use the microscope. Contact your
nearest Nikon representative to seek advice.
2

Unfasten the elevating section.

Tool: flathead screwdriver
Loosen and remove the tightening screw at the front of
the elevating section.
Chapter 1
Assembly
Input voltage
Tightening
7
OFF ON
FASTENING
Ni-E POSITION SW CONTACT
ARM1
This device complies with Part
15 of the FCC Rules. Operation
is subject to the following
two conditions:
(1) this device may not cause
harmful interference, and
(2) this device must accept any
interference received,
including interference that
may cause undesired
operation.
This Class A digital apparatus
complies with Canadian ICES-003.
Cet appareil numérique de la
classe A est confirme à la
norme NMB-003 du Canada.
MODEL NI-CTLA
5 4 0 0 0 1
MADE IN JAPAN
100-240V~ 5A 50/60Hz
LAMP
label
Checking the input voltage
screw
NC B
ND
ND 11
32
8
OU T
IN
Unfasten elevating section