16
Attach the substage.
Tools: Hex driver (2 mm across flats)
Hex wrench (3 mm across flats)
(1)
Place the groove of the substage on the reference
guide bar in the elevating section of the main body.
Move the substage to the left side, push it against
the reference surface, and then tighten the
drop-proof fixing screws (x3) using a hex wrench (3
mm across flats).
(2)
Put the provided elevating section cover onto the
front of the elevating section and tighten the
provided screws (x2) using a hex driver (2 mm
across flats).
Elevating section front cover
When you intend to attach the motorized universal
condenser in "18 Attach the condenser. ", you do not
need to attach the elevating section front cover in this
step (2).
Chapter 1
Assembly
Elevating
section cover
19
Substage
fixing screw
Substage fixing screw
(Substage from the front)
Attaching the substage
Attaching the elevating section cover
Reference
guide bar
Groove