Programming Scan - AnyTone AT-3318UV Instruction Manual

BASIC OPERATIONS
3. Press key, the top left corner of LCD displays "
emits "DUDU" beep and clear up frequency information of current channel, deletion is successful.
NOTE: This process can be applied for deleting FM radio channels.

Programming scan

Setup the frequency of L1 channel, U1 channel, L2 channel and U2 channel will realize VFO frequency
scanning border limited. L1 & L2 is starting frequency, U1 & U2 is end frequency. When VFO frequency
between L1~ U1 or L2 ~ U2, transceiver will scan frequencies between L1 ~ U1 or L2 ~ U2. When VFO
frequency is lower than L1 or L2, transceiver will scan frequencies higher than L1 or L2. When VFO
frequency is lower than U1 or U2, transceiver will scan frequencies higher than U1 or U2.
1. In VFO mode, enter desired frequency and relative setup, press
displays " " icon, then press
2. Rotate channel switch to choose desired channel number.
3. Press key, the top left corner of LCD displays "
"DUDU" beep, channels are saved successfully.
NOTE: To make this setup, L1 and U1 must in same frequency band. L2 and U2 must in same frequency
band.
" icon, press and hold
key switch into channel mode, channel number flashes
" icon, then press
key until transceiver
key, the top left corner of LCD
key until transceiver emits
21