Channel Scan Skip; Frequency Reverse - AnyTone AT-3318UV Instruction Manual

SHORTCUT OPERATIONS
in this mode. Press numeric key or
NOTE:
▼
Frequency scan is of all bands scan, it scans upwards as your STEPPING setting.
▼ In channel scan, the skipped channel is not in the line of scanning. Scan upwards as per channel no.
(please refer to channel scan skip).
▼
Frequency/channel scan can change scan direction by rotating channel switch, when find a matching carrier
wave and signaling, the transceiver will stay 5 seconds then go on scanning. (Please refer to scan setup)
If turn off radio in scan mode, when re-power on, radio will resume scanning automatically.

Channel Scan Skip

Under channel mode, press
then press key to set current arrow directed channel as Channel scan skip.
Repeat above operation to cancel channel scan skip.
1. LCD displayed " S
2. " S " icon disappeared means the current channel will be scanned.

Frequency Reverse

Under standby state, press
to set arrow directed channel as frequency reverse, repeat above operation to turn
off frequency reverse.
1. When LCD displays "R" icon, it means current arrow directed channel open the
frequency reverse function, the TX frequency and RX frequency is interchanged,
24
key to exit.
key, the top left corner of LCD displays "
" means the current channel will not be scanned.
key, the top left corner of LCD displays "
" icon,
" icon, then press key