Channel Name Edit; Short Call; Frequency/Channel Scan; Ctcss/Dcs Scan - AnyTone AT-5189 User Manual

Channel Name Edit

When transceiver is in channel name display mode, after pressing
key, LCD displays "FUNC", then press
FUNC
channel name program mode of current channel. Turn channel
selector to select the desired character or figure, press
key to move the cursor, press
V/M
finish program.

Short Call

While standby, press key to transmit optional signaling(DTMF,
CALL
2-Tone, 5-Tone) in current channel.

Frequency/Channel Scan

In relevant modes, press
"FREQ/CH SCAN?", then press
scan.
♦
Frequency Scan
In frequency mode, this function is designed to monitor signal
of every communicative frequency point of transceiver "STEP"
you have set. Press Microphone [UP/DOWN] or selector knob to
change scan direction, press any key (other than
Note:
When the transceiver is programmed with PA frequency and PB
frequency, in frequency mode (VFO), frequency subsection scan
is valid. For details, please refer to help options in programming
software.
key to get into the
CALL
CALL
key to confirm and exit when
SQ/C
key repeatedly until LCD displays
SCAN
key to enable frequency/channel
ENTER
key) to exit.
FUNC
♦
Channel Scan
In channel mode, this function is designed to monitor signal in every
channel. Press Microphone [UP/DOWN] or the selector knob to
change scan direction, press any key (other than
key and

CTCSS/DCS Scan

Press key repeatedly until LCD displays "CTCSS/DCS SCAN?",
FUNC
then press
ENTER
the scan will pause for 15 seconds then scan again. Press any key
(other than
FUNC
Note:
Invalid when no signaling existed in current channel.
When the current channel signaling is set to CTCSS, the tran-
sceiver will scan CTCSS.
When the current channel signaling is set to DCS, the transceiver
will scan DCS.
Press Microphone [UP/DOWN] or turn selector knob to change scan
direction.
SHORTCUT OPERATIONS
key to start scan. When finding a matching signaling,
key) to exit.
6
key) to exit.
FUNC
13