Dual Watch; Emergency Alarm; Channel/Frequency Scan; Channel Scan Skip - AnyTone Dual Band FM Transceiver User Manual

6

duAl wAtch

In standby, hold key for over 0.5 second to enter Dual Watch
mode. The radio will scan the channel in every 5 seconds. When the radio
receives matching signal, it pause scanning until the signaling disappear.
Repeat
above operation to exit Dual watch.

eMeRGencY AlARM

To start emergency alarm, hold the right volume knob until the trans
-ceiver displays ALARM and emit alarm. Re-power on the transceiver to
exit alarm. This transceiver has 4 kind of alarm which can be setup by
programming software.

chAnnel/FRequencY ScAn

FReq uenc Y ScAn
In VFO mode, this function is designed to monitor signal of every
communicative frequency point of "step size" you have set.
11
In VFO mode, press the Main Band
21 During the scanning adjust the Main band selector knob or press
microphone [ UP/DOWN ] key will change the scan direction.
31
Press key to exit scan.
chAnn el Sc An
11
In channel mode, press the Main Band
21
During the scanning, adjust the Main band selector knob or press
microphone [ UP/DOWN ] key will change the scan direction.
31
Press key to exit scan.

chAnnel ScAn Skip

In channel mode, switch selector knob to choose the channel, then hold
www.at-5888uv.com
key to enter channel scan.
key to enter channel scan.
Shortcut Operations
for over 0.5 second, the radio prompts
"DU DU", and LCD displays "SKIP", and now
the current channel is Scan Skip.

chAnnel edit

11 In VFO mode, turn selector knob to select the desired frequency or
input frequency by MIC's numeric keys.
21
Hold key until the transceiver prompt
DU and the display of channel number flashes.
31
Turn selector knob to select the channel number to store. (If the
storage has data , the LCD will display the
frequency, otherwise will display"----------")
41
Press key, the LCD display MEN- IN, the channel edit completed.

ScAn RAnGe liMit

You can set the VFO scan frequency range by this function:
11
Choose upper limit and lower limit frequency, there are L1/U1- L5/
U5, five couple of limit frequency for selection. L stands for lower
limit and U stands for the upper limit. the upper limit must over the
lower limit frequency. Please refer to the
Channel Edit to setup the limit frequency.
21 In VFO mode, set the VFO frequency in
the range between upper and lower limit.
31
Press key to start scan in lmited range.

chAnnel copY

11
In channel mode, turn the selector knob to choose the channel.
21
Hold key until the transceiver prompt a Du and channel number
display flashes.
31 Turn selector knob to choose channel number for storage. ( If the
6
14