Function Menu Setup; Ctcss/Dcs Encode Setup - AnyTone AT-3318UV Instruction Manual

FUNCTION MENU SETUP

Menu 1-14 of this transceiver are channel operations. Channel operations temporarily changed the functions
of current channel. When power off or channel has been changed, the relevant setup will be erased. Only
under VFO mode, the channel operations will be saved until next change. Menu 15-45 is background
operation(menu 33-44 is memory bank setup, please refer to page 50-51), it is valid for all channels, the
relevant setup will be saved until next change.
The operating methods are as follows:
1. Press key, the top left corner of LCD displays "
2. Press / key to choose desired function.
3. Rotate channel switch to choose desired setting.
4. Press key or

CTCSS/DCS Encode Setup

1. Press key, the top left corner of LCD displays "
key to enter into function menu.
2. Press /
3. Press key to choose CTCSS, DCS or OFF, when DCS signaling is selected,
press key to choose DCS positive or inverse code.
4. Rotate channel switch to choose desired CTCSS/DCS code.
CTCSS: 62.5HZ-254.1HZ, 51groups in total, and 1 group user-defined code.
DCS: 000N-777I, 1024 groups in total. "N" stands for positive code, "I" stands
for inverse code.
5. Press or
Note: User-defined CTCSS encode must be setup by programming software.
28
key to confirm and exit.
key to choose NO.01 function item, it shows "T-CDC" on LCD.
key to confirm and exit.
" icon, then press
" icon, then press
key to enter function menu.