Tone Pulse Frequency Selection; Battery Save Setup - AnyTone AT-3318UV Instruction Manual

FUNCTION MENU SETUP
4. Press key or
NOTE: When current channel add 5TONE to be optional signaling, LCD displays 5TONE self ID code,
otherwise displays DTMF self ID code.

Tone Pulse Frequency Selection

This function is used for waking up sleeping repeater, it needs a certain intensity of Tone Pulse to wake
up sleeping repeater. In general, as long as the repeater has been waked up, no need to transmit Tone
Pulse again in preset time.
1. Press key, the top left corner of LCD displays "
menu.
2. Press / key to choose NO. 30 function item, it shows "TBST" on LCD.
3. Rotate channel switch to choose desired setup.
1750HZ, 2100HZ, 1450HZ, 1000HZ, 4 kinds of Tone Pulse for optional.
4. Press key or

Battery Save Setup

User can setup battery save ratio according to requirements. The standby time can be extended when
enable battery save function, but if save ratio setting too high, it may cause voice missing.
1. Press key, the top left corner of LCD displays "
2. Press / key to choose NO. 31 function item, it shows "SAVE" on LCD.
3. Rotate channel switch to choose desired setup.
OFF: Battery Save is disabled.
44
key to confirm and exit.
key to confirm and exit.
" icon, then press
" icon, then press
key enter into function
key enter into function menu.