Offset Frequency Direction Setup; Frequency/Channel Scan - AnyTone AT-3318UV Instruction Manual

SHORTCUT OPERATIONS

Offset Frequency Direction Setup

Under standby state, press
press key to choose offset frequency direction. There are 3 options, Positive
offset, Minus offset, shut off offset.
1. (+) Positive offset: Indicates TX frequency is higher than RX frequency. When
enable reverse function, the RX frequency is higher than TX frequency.
2. (-) Minus offset: Indicates TX frequency is lower than RX frequency. When
enable reverse function, the RX frequency is lower than TX frequency.
3. None: Indicates shut offset off.
Under frequency mode (VFO) or channel mode, press
direction(+), minus offset direction (-) , shut offset off one by one (Please refer to offset frequency setup).
NOTE: This function is unavailable in professional transceiver mode.

Frequency/Channel Scan

Under corresponding mode, press
key to start frequency scan or channel scan.
1. Frequency Scan
Under VFO mode, frequency scan is available. This function is used for monitoring
signal of various communication frequency by transceiver 'step' setup, press
numeric key or key to exit.
2. Channel Scan
Under channel mode, this function is used for monitoring signal of each channel
key, the top left corner of LCD displays "
key then press
key, the top left corner of LCD displays "
" icon,
key to choose positive offset
" icon, then press
23