Squelch Level Setup; Scan Dwell Time Setup - AnyTone AT-3318UV Instruction Manual

FUNCTION MENU SETUP

Squelch level setup

This function is used for setup intensity of receiving signals, transceiver will hear calls when receiving
signal intensity achieve preset data, otherwise, transceiver will keep mute.
1. Press key, the top left corner of LCD displays "
key enter into function menu.
2. Press / key to choose NO. 24 function item, it shows "SQL" on LCD.
3. Rotate channel switch to choose desired setup.
00~09: 10 levels of squelch in total for optional, "00" is minimum setup value (normally open).
4. Press key or

Scan Dwell Time Setup

There are three kinds of scan dwell time for optional.
1. Press key, the top left corner of LCD displays "
key enter into function menu.
2. Press / key to choose NO. 25 function item, it shows "SCAN" on LCD.
3. Rotate channel switch to choose desired setup.
5ST: When scanning matched signal, transceiver will stop scaning for 5seconds then resume.
10ST: When scanning matched signal, transceiver will stop scaning for 10seconds then resume.
15ST: When scanning matched signal, transceiver will stop scaning for 15seconds then resume.
2SP: When scanning matched signal, transceiver will stop scaning, 2seconds after signal disappears,
scanning will resume.
4. Press key or
key to confirm and exit.
key to confirm and exit.
" icon, then press
" icon, then press
41