Shock Absorber Spring Preload Adjustment; Shock Absorber Damping Adjustment - Husqvarna 2013 CR 125 Owner's Manual

SHOCK ABSORBER SPRING PRELOAD ADJUST-
MENT
Proceed as follows:
1. Place yourself on the right-hand side of the motorcycle.
2. Clean ringnut (1) and adjusting nut (2) of the spring (3).
3. Either with a hook wrench or an aluminium punch, loosen
the ringnut .
4. Turn the adjusting nut as required.
5. When the adjusting operation is over (according to your
weight and riding style), tighten the ringnut. (Torque for
both ringnuts: 40 Nm - 4 Kgm - 29,50 ft/lb).
6. Reassemble R.H. side panel and saddle.
WARNING*:Be careful not to touch hot ex-
haust pipe while adjusting the shock abosr-
ber.
3
2

SHOCK ABSORBER DAMPING ADJUSTMENT

Adjustment of the compression stroke is independent from the
rebound stroke.
A) COMPRESSION - Standard calibration:
1) Low damping speed:
- 15 clicks (± 2 clicks)
(register 4)
3) High damping speed:
- 15 clicks (± 2 clicks)
(register 6)
1
To reset the standard calibration, turn upper registers (1) and
(3) clockwise until reaching fully closed position.
Return then back for the mentioned clicks. In order to obtain a
smooth braking action, turn the registers anticlockwise.
the operation in order to obtain a harder braking action.
B) EXTENSION - Standard calibration:
- 18 clicks (± 2 clicks)
To reset the standard calibration, turn lower register (2) clock-
wise until reaching fully closed position. Return then back for
the mentioned clicks. In order to obtain a smooth braking
action, turn the register anticlockwise. Reverse the operation
in order to obtain a harder braking action.
+
3
-
1
SPECIFICATIONS - OPERATION - MAINTENANCE
Reverse
2
EN - 31