Fine Adjustment Of Black Density - Toshiba e-Studio3511 Service Handbook

3.7.9 Fine adjustment of black density

The density of black side on scanned image is adjusted at color-scanning.
Code Original mode
1075 Text
1076 Printed Image
1077 Photo
Note:
Be careful for the value not to be too large since the gradation is reproduced worse in darker side.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes and press the [START] button.
(3) Key in the adjustment values. Acceptable values : 0 to 4. (To correct the value once keyed in,
press [CLEAR] button.)
Press the [ENTER] or [INTERRUPT] button to store the value in memory. → The equipment
(4)
goes back to the ready state.
(5) Let the equipment restart and perform scanning job.
(6) If the desired image has not been attained, repeat step (1) to (5).
3.7.10 RGB conversion method selection
The color space conversion method of image is decided at color-scanning.
Code Original mode
1080 Text
1081 Printed Image
1082 Photo
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes and press the [START] button.
(3) Key in the adjustment values. Acceptable values : 0 to 3. (To correct the value once keyed in,
press [CLEAR] button.)
Press the [ENTER] or [INTERRUPT] button to store the value in memory. → The equipment goes
(4)
back to the ready state.
(5) Let the equipment restart and perform scanning job.
(6) If the desired image has not been attained, repeat step (1) to (5).
November 2003 © TOSHIBA TEC
The larger the value is, the black side of the image becomes darker.
Acceptable values: 0 to 4 (Default: 0)
0: sRGB 1: AppleRGB 2: ROMMRGB
(Default: 0)
3 - 43
<Adjustment Mode (05)>
Remarks
<Adjustment Mode (05)>
Remarks
3: AdobeRGB
e-STUDIO3511/4511 ADJUSTMENT