Toshiba e-Studio3511 Service Handbook page 238

(3) Assembling carriage wires
Winding the wire around the wire pulley:
a. Pull the Ø3 ball terminal located at the center of the wire into a hole on the wire pulley. One
end of the wire with a hook attached comes to the outside.
b. Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be
wound are as follows:
• 2 turns toward the opposite side of the boss
• 4 turns toward the boss side
Notes:
Pay attention to the followings when the wires are wound around the pulleys:
• Do not twist the wire.
• Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
• Each turn should be pushed against the previously wound turn so that there is no space
between them.
2 turns
Ball terminal
Hook
[Rear]
e-STUDIO3511/4511 ADJUSTMENT
4 turns
No space between turns
Color: Silver
Fig. 3-904
3 - 48
4 turns
Color: Black
[Front]
November 2003 © TOSHIBA TEC
2 turns
Ball terminal
Hook