Toshiba e-Studio3511 Service Handbook page 303

*c3. Install the 2nd transfer front guide after the cleaning of the paper dust removal brush.
Push the 2nd transfer front guide to the transfer belt unit and fix it securely as shown in the
figure below.
*e1. Separation roller (SFB)
Apply an even coat of grease (Alvania No.2) to all round the inside of the spring.
When replacing the separation roller, apply adequate amount of white grease (Molykote
HP-300) on the places of the holder shown in the figure (4 places).
Note:
Make sure that the grease does not adhere to the roller surface. Wipe it off with alcohol if
adhered.
Apply grease on the
inner surface
November 2003 © TOSHIBA TEC
Fig. 4-208
Fig. 4-209
4 - 17
Apply white grease
Fig. 4-210
e-STUDIO3511/4511 PREVENTIVE MAINTENANCE