Toshiba e-Studio3511 Service Handbook page 495

(8) Click the [OFFLINE] button.
(9) Select the transmit media and click the [OK] button.
In case of RS-232C connection: Select "Serial"
In case of USB connection:
* The connection status between the printer driver installed in the PC and the equipment to be
connected is displayed only when "USB" is selected. Select the equipment to be updated and
click the [Activate FSMS] button.
Tip:
The content of "Status" display can be renewed to the latest status by clicking the [Refresh] button. When the
status is displayed as "Disconnected" because the start up of the equipment is delayed, the status can be
renewed to "Connected" by clicking this.
November 2003 © TOSHIBA TEC
Select "USB"
6 - 39 e-STUDIO3511/4511 FIRMWARE UPDATING