Toshiba e-Studio3511 Service Handbook page 25

Error code Classification
EA40 Finisher jam
(Finisher section)
EA50
EA60
EA70
EA80 Finisher jam
EA90 (Saddle stitcher
section)
EAA0
EAB0
EAC0
EAD0 Other paper jam
EAE0 Finisher jam
EAF0 Finisher jam
(Finisher section)
EB30 Finisher jam
EB50 Paper transport
jam
EB60
November 2003 © TOSHIBA TEC
Door open jam:
(1) The finisher has been released from the equipment during
printing. [MJ-1022]
(2) The upper/front cover of the finisher section or the upper/
front door of the puncher section has opened during
printing. [MJ-1023/1024]
Stapling jam: Stapling is not performed properly.
[MJ-1022/1023/1024]
Early arrival jam: The inlet sensor detects the paper earlier than
a specified timing. [MJ-1022/1023/1024]
Stack delivery jam: It cannot deliver the stack of paper on the
intermediary process tray to the stack tray. [MJ-1022]
Stapling jam: Stapling is not performed properly. [MJ-1024]
Door open jam: The delivery cover or inlet cover has opened dur-
ing printing [MJ-1024].
Power-ON jam: Paper exists at No.1 paper sensor, No. 2 paper
sensor, No.3 paper sensor, vertical path paper sensor or
delivery sensor when power is turned ON. [MJ-1024]
Transport stop jam: The paper which passed through the inlet
sensor does not reach or pass No.1 paper sensor, No. 2 paper
sensor, No.3 paper sensor or delivery sensor. [MJ-1024]
Transport delay jam: The paper which has reached the inlet
sensor does not pass through the inlet sensor. [MJ-1024]
Print end command time-out jam: The printing has not finished
normally because of the communication error between the SYS
board and LGC board at the end of printing.
Receiving time time-out jam: The printing has been interrupted
because of the communication error between the equipment
and finisher when the paper is transported from the equipment
to the finisher.
Stack return jam: It cannot load the paper which passed through
the delivery roller on the intermediary process tray. [MJ-1022]
Ready time time-out jam: The equipment judges that the paper
transport to the finisher is disabled because of the communication
error between the equipment and finisher at the start of printing.
Paper remaining on the transport path: The multiple feeding of
preceding paper caused the misfeeding of upcoming paper.
Paper remaining on the transport path: The multiple feeding of
preceding paper caused the misfeeding of upcoming paper
(redetection after no jam is detected at [EB50]).
2 - 5
e-STUDIO3511/4511 ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
Trouble-
shooting
Ch. 5.1.7 (2)
Ch. 5.1.7 (2)
Ch. 5.1.7 (2)
Ch. 5.1.7 (2)
Ch. 5.1.7 (3)
Ch. 5.1.7 (3)
Ch. 5.1.7 (3)
Ch. 5.1.7 (3)
Ch. 5.1.7 (3)
Ch. 5.1.4
Ch. 5.1.7 (5)
Ch. 5.1.7 (2)
Ch. 5.1.7 (5)
Ch. 5.1.3
Ch. 5.1.3