Toshiba e-Studio3511 Service Handbook page 53

Procedure 6
[Digital key]
[0][5]
[POWER] (Code)
Procedure 7
[Digital key]
[0][5]
(Code)
[POWER]
*[CANCEL] or [CLEAR]
Procedure 10
[0][5] [Digital key]
[POWER] (Code)
Procedure 14
[0][5]
[Digital key]
[POWER]
(Code)
Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment mode.
In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after it has
become ready state and then start up the adjustment mode again.
November 2003 © TOSHIBA TEC
Automatic
(
[START]
adjustment
*[CANCEL] or [CLEAR]
* When the automatic adjustment ends abnormally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
[CANCEL]
Automatic
(
[START]
adjustment
* When the automatic adjustment ends abnormally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
[Digital key]
[START]
(Sub code)
[ENTER] or [INTERRUPT]
(Value unchangeable)
[START] [Digital key]
[START]
(Sub code)
[CLEAR]
(Corrects value)
2 - 33
) ( [FAX] [START] )
(Test copy)
[ENTER]
(
)
Stores value
( )
[START]
in RAM
(Test copy)
Value
( )
[START]
displayed
[ENTER]
[UP] or [DOWN]
or
(Adjust a value)
[INTERRUPT]
Stores value
(
in RAM
[CANCEL]
(Corrects value)
e-STUDIO3511/4511 ERROR CODE AND SELF-DIAGNOSTIC MODE
[POWER]OFF/ON
(Exit)
[FAX]
)
[POWER]
OFF/ON
(Exit)
[POWER]
[START] OFF/ON
(Exit)
[FAX]
( )
[POWER]
OFF/ON
[START]
(Exit)
) (Test copy)