(G) Right Margin; (H) Bottom Margin - Toshiba e-Studio3511 Service Handbook

(g) Right margin

1. While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
2. Open the platen cover or RADF.
3. Press [FAX] → [START] to make a copy at the mode of A3/LD, 100%, Black, Text/Photo and
lower drawer.
4. Measure the blank area F at the right side of the copied image.
5. Check if the blank area F is within the range of 2+1 mm, 2-0.5 mm.
6. If not, use the following procedure to change values and repeat the steps 3. to 5. above.
(Adjustment Mode) → (Key in the code [432]) → [START]
<Procedure>
→ (Key in a value (acceptable values : 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory).
→ ("100% A" is displayed.)
* The larger the adjustment value is, the wider the blank area at the right side

(h) Bottom margin

1. While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
2. Open platen cover or RADF.
3. Press the [FAX] → [START] to make a copy at the mode of A3/LD, 100%, Black, Text/Photo
and lower drawer.
4. Measure the blank area G at the trailing edge of the copied image.
5. Check if the blank area G is within the range of 2±0.5 mm.
6. If not, use the following procedure to change values and repeat the steps 2. to 4. above.
(Adjustment Mode) → (Key in the code [433]) → [START]
<Procedure>
→ (Key in value (acceptable values : 0 to 255))
→ [ENTER] or [INTERRUPT] (stored in memory)
→ ("100% A" is displayed.)
* The larger the adjustment value is, the wider the blank area at the trailing edge
e-STUDIO3511/4511 ADJUSTMENT
becomes (approx. 0.04 mm/step).
Feeding direction
becomes (approx. 0.04 mm/step).
Feeding direction
F
Fig. 3-406
G
Fig. 3-407
3 - 18 November 2003 © TOSHIBA TEC