KYMCO Downtown 200i Service Manual page 201

16
. BATTERY/CHARGING SYSTEM
BATTERY
REMOVAL
The battery is in the battery box below seat.
1. Remove the seat.
2. Remove the met-in box
3. Remove four screws and then the battery
retainer.
4. Pull battery out to expose the terminal
leads
5. Disconnect the negative (-) terminal lead
from the battery first, then disconnect the
positive (+) terminal lead.
6. Remove the battery from the battery box.
BATTERY INSTALLATION
Install in the reverse order of the removal.
When install the battery, first connect
the positive (+) cable and then negative
(-) cable to avoid short circuit.
VOLTAGE INSPECTION
Remove the battery cover.
Measure the battery voltage by using a
commercially available digital multimeter.
Voltage (20ºC/68ºF):
Fully charged: 13.0 ~ 13.2 V
Insufficient charged: < 12.3 V
DOWNTOWN 200i
Screws
Terminal (-) Terminal
16-4