12. COOLING SYSTEM
Install the dowel pins and a new gasket and
then install the water pump assembly to the
right crankcase cover.
Tighten 12 bolts to secure the right crankcase
cover.
*
When installing the water pump assembly,
aligning the groove on the water pump shaft
with the tab on the oil pump shaft.
WATER PUMP/IMPELLER
INSTALLATION
When the mechanical seal is replaced, a new
seal washer must be installed to the impeller.
Install the impeller onto the water pump shaft.
Torque: 1.0~1.4 kgf-m (11.8 N-m)
*
The impeller has left hand threads.
Install two dowel pins and a new gasket.
Install the water pump cover and tighten the 4
bolts.
Torque: 1.0~1.4 kgf-m (11.8 N-m)
DOWNTOWN 200i
Seal Washer (Porcelain)
Impeller
Mechanical (Water) Seal
12-10