KYMCO Downtown 200i Service Manual page 122

12. COOLING SYSTEM
THERMOSTATIC SWITCH
When the coolant temperature is lower than
88~92 ℃, the thermostatic switch OFF.
When coolant temperature is over 88~92 ℃,
the thermostatic switch ON.
RADIATOR INSTALLATION
Install the fan rubber on the radiator with three
bolts.
Install the radiator on the radiator bracket with
three bolts/nuts.
Connect the upper and lower hoses and secure
them with hose bands.
Connect the thermostatic switch wire.
Connect the fan motor wire couplers.
Connect the overflow tube and secure with the
tube clamp.
Fill the radiator with coolant.
Connect the vent tube to the radiator filler.
After installation, check for coolant leaks.
Connect the outlet tube of the reservoir and
secure with the tube clamp.
＊
If you want to refill the coolant, the
following procedure must be checked.
1. Please make the radiator filler and the air
vent tube to be separated.
2.
Start the engine, filled in the coolant till
the coolant flowed out from the air vent
tube.
12-7
Thermostatic Switch
Overflow Tube
DOWNTOWN 200i
Air Vent Tube