Finisher Or Stacker Sensor (Pass Thru) Removal - Lexmark C792 series Service Manual

Finisher or stacker sensor (pass thru) removal

See "Finisher/High-capacity output stacker assembly" on page 7-25
1.
Remove the finisher from the printer.
2.
Remove the finisher rear cover. See
3.
Remove the finisher front cover. See
4.
Open the left access door, and pry out the left hinge (A) to lower the door.
5.
Push the door to the right to release the left hinge, and then release the right hinge.
6.
Remove the four screws (B), and pull out the deflector plate.
7.
Disconnect the cable (C) from the sensor.
8.
Remove the screw (D) to remove the sensor bracket.
"Finisher or stacker rear cover removal" on page
"Finisher or stacker front cover removal" on page
for the part number.
4-269.
4-260.
Repair information
5062
Previous
Next
Go Back
4-275