Lexmark C792 series Service Manual page 400

5062
•
Place the slot in the ITU DS roller plate over the ridge on the frame, and then swing the plate into place to
reattach the two screws.
•
Check the alignment of the reference edge. See
page 4-147.
Notes:
•
•
•
4-146
Service Manual
When installing the staging paper path reference edge, do not turn the adjustment screw
during installation.
Do not replace, or adjust the printhead and the staging paper path reference at the same time.
See "Pick arm stuck down service check" on page 2-164
position.
"Aligning the staging paper path reference edge" on
to put the pick arm back to
Previous
Next
Go Back