Htu Controller Card Removal - Lexmark C792 series Service Manual

HTU controller card removal

1.
Remove all output options from the printer.
2.
Remove the rear standard bin cover. See
3.
Disconnect all cables connected to the controller card.
4.
Remove the four screws (A).
Installation note: Be sure to connect the solenoid cables into the correct connector. There are black lines (A) on
the cable connector that goes into the black connector on the system board.
"HTU rear standard bin cover removal" on page
5062
4-312.
A
4-289
Repair information
Previous
Next
Go Back