Redrive Bubble Sensor Service Check - Lexmark C792 series Service Manual

Redrive bubble sensor service check

Step Questions / actions
1 Open the left access door, and remove the
fuser. Check the redrive bubble sensor flag
for damage.
Is the redrive bubble sensor flag
damaged?
2 Turn the printer off, and open the system
board shield. Check the cable in connector
JRDR1 for proper connection to the system
card.
Is the cable properly connected?
3 Replace the paper path redrive assembly.
See "Paper path redrive assembly with
sensors removal" on page 4-117
Does the error reoccur?
Yes
Replace the paper path
redrive assembly. See
"Paper path redrive
assembly with sensors
removal" on page 4-117.
Go to step 3.
Replace the system board.
See "System board
removal" on page 4-151.
5062
No
Go to step 2.
Reseat the cable.
Problem solved.
2-165
Diagnostic information
Previous
Next
Go Back