Finisher Or Stacker Led Sensor Cover Removal; Finisher Or Stacker Left Access Door Assembly Removal - Lexmark C792 series Service Manual

5062

Finisher or stacker LED sensor cover removal

1.
Remove the option from the printer.
2.
Remove the standard output bin LED lens. See
lens removal" on page
3.
Remove the sensor (finisher media bin present). See
present) removal" on page

Finisher or stacker left access door assembly removal

See "Finisher/High-capacity output stacker assembly" on page 7-25
1.
Remove the option from the printer.
2.
Open the left access door.
3.
Using a screwdriver, force the rear hinge (A) out of the slot to lower the door all the way, and then pry the
rear hinge out by pushing the door to the front.
4.
Once the rear hinge has been disengaged, pull out the front hinge (B).
5.
Remove four screws (C), and turn over the beacon cable cover.
4-262
Service Manual
"Finisher or stacker standard output bin LED and LED
4-277.
4-273.
"Finisher or stacker sensor (finisher bin media
for the part number.
Previous
Next
Go Back