Lexmark C792 series Service Manual page 299

4.
From the memory block you are removing, press the lever (E) to access the sensor, push the right side of
the sensor to remove it, and then disconnect the cable from the sensor.
5.
Remove the two screws (F), and pull to remove the memory block. As you pull the cable through, be sure
to leave the string in the path from the memory block to the system board.
Installation notes:
1.
Attach the memory block and tie the string to its cable.
2.
Connect the sensor cable to the sensor, and then attach the sensor to the memory block.
3.
From the rear of the printer, pull the string to feed the memory block cable through the frame to the
system board.
Warning: Be sure to pull the cable into the system board cage area as far as possible. Failure to do may
damage the cables.
E
F (88A0212)
Repair information
5062
Previous
Next
Go Back
4-45