1
4
3
6
GENERAL PROCEDURES
Rear chassis complete with mudguard and air box removal
-
Remove saddle, side panels, tank, silencer, battery, oil reservoir and control
unit (in this order), as outlined in the relevant paragraphs.
-
Shear the plastic clips securing wiring to rear chassis.
H02718
- Disconnect air temperature sensor connector (1) positioned inside filter box
(widen tabs, and pull).
-
Disconnect the connector (2) between main wiring harness and rear wiring
harness.
-
Using an 8 mm wrench, loosen screw (3), and remove bracket (4) from fuse
and flasher support.
2
H02719
- Loosen clamp (5) securing filter box to carburettor.
5
H02720
-
Using a 10 mm wrench, loosen screws (6) on both sides of chassis.
H02721
E.8
Ed. 05-2011