Table of Contents
Advertisement
3
2
6
3
B
H02696
SETTINGS AND ADJUSTMENTS
Throttle cable adjustment
The throttle cable may be adjusted using the adjuster screw on the cable itself
or the adjuster screw on the carburettor cover. To check for proper adjustment
1
of throttle cable, proceed as follows:
-
move the rubber cap (1) aside;
-
move transmission sheath to and fro to ensure a play of approx. 1 mm;
-
should play be greater than 1 mm (0.04 in.), loosen lock nut (2) and register
(3); should play less than 1 mm (0.04 in.), then tighten lock nut and regis-
ter;
-
if register (3) should not provide sufficient movement to allow for correct
adjustment, then adjust register placed on carburetor.
There should be approx. 1 mm (0.04 in.) play on latter register; otherwise,
move the rubber cap (4) aside and, after loosening the check nut (6), loosen
H02640
or tighten the adjuster screw (5) to reduce or increase free play.
4
5
H02641
Adjustment of the starter lever
-
Remove the rubber protection (1).
-
Loosen the check nut (2) and turn the tensioner (3).
Free play (B) must be at least 5 mm (0.2 in.).
-
When through with the adjustment, tighten the check nut (3) and refit the
1
rubber protection (1).
2
H02639
Operation with damaged throttle cable could result in an unsafe
riding condition.
D.6
Ed. 05-2011
Advertisement
Chapters
Table of Contents
