Husqvarna WRE 125 2011 Workshop Manual page 205

1
2
Ed. 05-2011
ELECTRICAL SYSTEM
DIGITAL DASHBOARD, WARNING LIGHTS
The motorcycle is fitted with a digital dashboard on which 3 warning lights are
3
also available: high beam, turning indicators and fuel reserve.
1 - BLUE warning light "High beam"
2 - GREEN warning light "Turning indicators"
3 - RED warning light "Engine lubricating oil reserve" + FAIL LAMP
When the ignition key is turned to the IGNITION position, the dashboard display
lights up (amber colour).
A
NOTE:
- At every connection with the battery, the dashboard shows the version of the
H02579
test SW for the first 2 seconds; after the check routine, the dashboard shows
the last planned function.
- When the engine is turned off, the dashboard does not show any functions.
- To select dashboard functions and reset functions, use the SCROLL button
(A)
The functions, which can be selected in this sequence, are as follows:
1- SPEED / ODO
2- SPEED / CLOCK
3- SPEED / TRIP
4- SPEED / LAP TIMER
5- SPEED / HOUR COUNTER
1- SPEED / ODO
A
IMPORTANT: in the event of a MALFUNCTION, the FAIL wording followed by
H02580
a number will be shown on the tester DISPLAY.
For alarm list, see point 6 diagnostic.
1- SPEED (Kmh or mph) / ODO
- SPEED: vehicle speed - maximum value: 299 Km/h or 299 mph;
- ODO: odometer - maximum value: 99999 Km.
To change unit from kilometres to miles or miles to kilometres, proceed as fol-
lows:
1) set to figure 1, turn the key to OFF and push SCROLL (A);
2) place the ignition key in the IGNITION position and hold down the SCROLL
button (A) until the word "Km/h" is displayed;
3) the display will now alternate between "Km/h" and "Mph Miles", push the
SCROLL button (A) again while the desired unit is displayed.
A
H02581
M.31