D
A primary drive gear on crankshaft
B primary drive gear on clutch housing
C Countershaft idle gear
D Countershaft gear
ENGINE ASSEMBLY
Primary drive and countershaft gears line up
Fit a dial gauge on the head to determine the condition of the piston at the top
dead centre.
Insert on the primary shaft the three-tab washer (1), the inner spacer and the
A
two roller cages (2) with spacer (3). Then, with piston at top dead centre, fit
the clutch housing so that the punched references on gears are positioned as
shown in the figure.
B
C
H06613
3
1
2
H06614
H.12
Ed. 05-2011