Husqvarna WRE 125 2011 Workshop Manual page 79

6
8
10
11
Ed. 05-2011
GENERAL PROCEDURES
- Loosen clamp (6), and praise carburettor (7) off the intake duct.
7
H02772
- Open clamps (8), and disconnect pipes (9) from engine (10).
9
9
8
H02773
- Using a 27 mm wrench, loosen nut (11) on swinging arm shaft then, work-
ing on the right side, remove swinging arm shaft until releasing engine, but
without removing swinging arm.
H02775
- Using a 12 mm wrench on the left side and a 10 mm wrench on the right
12
side, loosen nuts (12), then remove engine retaining screws.
- Slightly raise engine, and remove it from bike right side.
H02774
E.25