2
5
4
H06644
Ed. 05-2011
SETTINGS AND ADJUSTMENTS
Lubricating oil pump drainage
-
Remove the saddle and side panel, as outlined in the relevant paragraph.
Drainage is to be done with the engine off.
Using the special pliers, loosen clamp onto pump (5) to carburettor pipe (4),
and disconnect pipe. place a container under it and check that the ignition key
(1) is in OFF:
-
disconnect oil pump connector (2);
- rotate the ignition key (1) to ON and reconnect the connector (2).
1
A five minute pump cycle will be carried out, during which the warning light (3)
will flash every 0.5 sec.
After this operation, connect the hose to the carburettor again.
Lubricating oil pump does not require any overhaul intervention, and its parts do
H02659
not have to be removed or checked.
3
H06643
4
D.15