Table of Contents
Advertisement
ENGINE DISASSEMBLY
Right-hand side component and cover disassembly
4
3
7
6
2
5
4
8
1
3
16
15
11
13
10
18
19
9
8
14 13
12
20 17
H06625
To make disassembly operations easier, it is recommended to place engine block onto a rotating support, securing it on the upper
side.
Loosen screw (1), and remove the kick start lever (2). (8 mm wrench)
Loosen the two screws (3), and remove regulator cover (4).
- Remove the complete regulator (5); on reassembly, check the O-ring (6) for damages and make sure that the two bushings (7) are
correctly positioned.
Remove water pump cover (8), by loosening the
retaining screws (9), (10) and (11).
Remove water pump impeller (12) by turning it by hand counter clockwise.
On reassembly, take care that pump cover centring bushings (13) are positioned close to the two longer screws, and replace gasket
(14).
Loosen the eight retaining screws (15 and 16, two and six pieces respectively) on crankcase half right-hand side cover.
Remove cover, by levering onto starter shaft end. Collect seal.
Slide out water and oil pump control shaft, complete with nylon gears (17) and (18), from inside the cover. Collect shims (19) and
(20).
Ed. 05-2011
F.3
Advertisement
Chapters
Table of Contents
