Husqvarna WRE 125 2011 Workshop Manual page 140

2
2
2
3
2
2
2
ENGINE ASSEMBLY
Install the gasket on the crankcase half, and check the correct position of the
centring bushings; proceed to RH cover reassembly, taking care that the water
pump control shaft end can be easily installed inside its special cover seat.
H06638
Insert the eight retaining screws, taking care that the one at the rear centring
bushing (white arrow) is longer than the other ones. Moreover, the oil pump
pipe retaining bracket must be installed under the screw placed on top of the
kick start lever.
H06639
Screw assembly diagram
1 - M6X20 screw - No. 1 piece.
2
2 - M6X25 screw - No. 7 pieces.
5 3 - M6X35 screw - No. 1 piece.
4 - M6X45 screw - No. 1 piece.
5 - M6X55 screw - No. 1 piece.
4
1
H06640
H.16 Ed. 05-2011